Tag Archives: commuter
General

OtterBox Commuter and Defender for iPhone 4/4S (Class A)

By on Sunday, January 6, 2013

After a few months of use, my knock-off OtterBox Commuter chipped and cracked so I looked for replacement case. Over the holidays, Edong accompanied me in the search. It was tough going because every shop were carrying mostly iPhone 5 cases. We did find a knock-off OtterBox Commuter at the place where he got his own case. But it was P650 and it wasn’t even well-made. Today, I dropped by the phone accessories section of a nearby mall and ended up at the stall of this Chinese guy at the far end of the section. He showed me not just a Commuter (P250) but also a Defender (P700). They were good copies. Definitely better than my old one. The Commuter even had stiffer silicone similar to the one being used by OtterBox. I asked for his last price and he said P200 for the former and P600 for the latter. I asked him if I can get both for P750 and after some thought he agreed. But I’m sure he still got a tidy profit. In fact, the other stall keepers were actually getting stocks from him while we were transacting.

0
General

OtterBox Commuter for iPhone 4/4S (Class A)

By on Monday, August 27, 2012

The Otterbox Commuter is a mid-level risk case slotting between a bumper and a heavy-duty case like the Otterbox Defender. Unfortunately, they’re rather expensive at P2,100 or thereabouts at local shops. And then I saw Edong’s Class A OtterBox Commuter case for his Samsung Galaxy S-III. “Class A” is a euphemism for knock-off so it was way cheaper. I was impressed with the quality (for the price) so I got one for my own phone.

Just like its “inspiration”, the case is composed of two pieces: a silicone inner layer and a polycarbonate outer layer. The silicon layer covers the back and wraps around the edges giving the screen a slightly raised protective rubber bezel. This protects the screen from direct contact when the phone is face down. The buttons have touch-through covers but are still reasonably easy to press. The proprietary Apple USB port is covered by a flap and should be easily accessible to most accessories. There are cutouts for the camera, flash, and silent switch. The silent switch is still easily accessible with a finger.

The polycarbonate layer clips onto and around the silicone layer giving it another layer of protection. The whole case fits the iPhone snugly and makes it look like it could bounce off the floor. I’m just concerned about the the durability of the polycarbonate considering this is just a “Class A”. But at P300 (and could be lower) a pop, it should be less painful to replace.

 

 

0